Mitsubishi — 23. PISTON AND CONNECTING ROD

4M41 ENGINE - Piston and Connecting Rod 11B-23-11 11 (2) Piston Ring-to-Piston Ring Groove Clearance 1) If the measured clearance exceeds the specified limit, replace the defective part. 6, 7, 8 Standard value: 1st compression ring 0.03 - 0.08 mm 2nd compression ring 0.07 - 0.10 mm Oil ring 0.03 - 0.06 mm Limit: 0.15 mm NOTE The 1st compression ring 6 is of full keystone type. Measure the clearance with a feeler gauge G while pressing the ring against the piston pin groove bottom with a straight edge H . G 11 Caution 1. Clear all carbon deposits from the ring groove of the piston 11 and measure the clearance all around the ring groove. 2.

When it becomes necessary to replace any of the rings 6, 7 and 8, replace all of them as a set. H 6 4ME0454 11 3. PISTON PIN (1) Measure the clearance between piston pin 10 and piston 11 . If the reading exceeds the specified limit, replace the defective part. Standard value: 0.007 - 0.021 mm Limit: 0.05 mm 10 (2) Measure the clearance between piston pin 10 and connecting rod bush 13 . If the reading exceeds the limit, replace the defective part. 10 Standard value: 0.03 - 0.05 mm Limit: 0.1 mm 13 PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added