Mitsubishi — 23. PISTON AND CONNECTING ROD

4M41 ENGINE - Piston and Connecting Rod 11B-23-12 A 4. CONNECTING ROD (1) Fit the connecting rod bush 13 and piston pin 10 in the connecting rod 15 . (2) Measure the bend A and twist B of the connecting rod 15 . If either reading exceeds the specified limit, replace the connecting rod. 100 mm C 10 C : Connecting rod aligner (measuring device) Limits: Bend 0.05 mm Twist 0.1 mm Caution 1. Attach the connecting rod 15 to the connecting rod aligner C with the upper and lower connecting rod bearing shells installed in place. 2. Tighten the connecting rod cap nut to a torque of 49 ± 5 Nm. B 100 mm 10 C PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added