Komatsu — 4.9.1.b CLEAN INSIDE OF COOLING SYSTEM

MAINTENANCE PROCEDURE Antifreeze is flammable, so keep it away from flame. Antifreeze is toxic. When removing the drain plug, be careful not to get water containing antifreeze on you. If it gets in your eyes, flush your eyes with large amount of fresh water and see a doctor at once. Use city water for the cooling water. If river water, well water or other such water supply must be used, contact your Komatsu Utility Dealer. We recommend use of an antifreeze density gauge to control the mixing proportions. Prepare a container with a capacity of at least 3.3 liters (0.87 US gal) to catch the coolant. Prepare a water inlet hose. 1. Open the engine rear cover and cooling cover.

For de­ tails, see Section "3.2.10 COOLING COVER". 2. Check that the cooling water temperature has gone down enough to make it possible to touch the radiator cap sur­ face by hand, then turn radiator cap (1) slowly until it con­ tacts the stopper to release the pressure. 3. Following this, push radiator cap (1), turn it until it contacts the stopper, then remove it. 4. Place a container to catch the coolant under the drain ho­ se installed to drain valve (2) and under coolant drain plug (3) on the engine block. 5. Open drain valve (2) and drain the water. Remove drain plug (3) from the engine cylinder block and drain the water. 6.

After draining the antifreeze solution, close drain valve (2) and tighten drain plug (3), then fill with clean water. After the radiator is filled with water, start and run the engine at low idling speed. After the water temperature rises above 90°C (194°F), run the engine for about 10 minutes. 7. Stop the engine, then open drain valve (2) and remove drain plug (3) to drain the water. 8. Close drain valve (2). Wind seal tapes onto drain plug (3), then tighten it. 9. Decide the proportions of antifreeze and water according to the table for the mixing rate of water and antifreeze. 10. After the engine warming up, check that each gauge and caution lamp are in normal condition.

If any abnormality is found, carry out adjustment or repairs. Operate the machine under a light load until the engine water temperature gauge (2) points to the white range (monitor panel spec.) or the green range (gauge panel spec.). To remove the air in the coolant, run the engine for 5 min­ utes at low idling, then for another 5 minutes at high idling. (While doing this, leave the radiator cap removed). 176 WARNING