Komatsu — 4.9.1.e DRAIN WATER AND SEDIMENT FROM FUEL TANK

MAINTENANCE PROCEDURE 4.9.1.d CLEAN WATER SEPARATOR ELEMENT Do not bring any fire or flame close. Prepare a filter wrench Prepare a container to catch the fuel that is drained. 1. Open the engine rear cover. 2. Set handle (1) of the water separator to CLOSED position (A). 3. Loosen drain plug (2) and drain the accumulated water in­ to a container until red ring (3) reaches the bottom. Then tighten plug (2). 4. Use a filter wrench to loosen ring (4), take out element cup (5), then remove element (6). Be careful not to lose red ring (3) inside the cup. 5. Wash the inside of cup (5) and element (6) with diesel fuel or flushing oil. 6. After washing, install element (6). 7.

Insert red ring (3) in element cup (5), fill with fuel, then in­ stall to the filter holder and tighten ring (4). Tightening torque: 14.7 to 19.6 Nm (1.5 to 2.0 kgf·m, 10.8 to 14.5 lb.ft.). 8. Set handle (1) of the water separator to OPEN position (B). 9. After washing the water separator, bleed the air. For details of the procedure for bleeding the air, see "4.9.3.c REPLACE FUEL FILTER CARTRIDGE" - " AIR BLEEDING". 4.9.1.e DRAIN WATER AND SEDIMENT FROM FUEL TANK IMPORTANT Never use trichlene for washing the inside of the tank. Use diesel fuel only. Carry out this procedure before operating the machine. Prepare a container to catch the fuel that is drained. 1.

Swing the upper structure so that drain valve (1) is be­ tween the tracks. 2. Open the engine rear cover and cooling cover. For de­ tails, see Section "3.2.10 COOLING COVER". 3. Open drain valve (1) and drain the sediment and water collected at the bottom together with the fuel. When doing this, be careful not to get fuel on yourself. 4. When only clean fuel comes out, tighten drain valve (3). 179 WARNING