Komatsu — 4.9.1.g CHECK AND ADJUST TRACK TENSION (Machine equipped with road liner, steel shoe)

MAINTENANCE PROCEDURE 4.9.1.f CHECK AND TIGHTEN TRACK SHOE BOLTS (Machine equipped with road liner, steel shoe) If the machine is used with track shoe bolts (1) loose, they will break, so tighten any loose bolts immediately ROAD LINER MOUNTING BOLT - CHECK/TIGHTEN Tighten to a tightening torque of 127 to 142 Nm (13 to 14.5 kgf·m, 94 to 104.9 lb.ft.) then check that the nut and shoe are in close contact with the link contact surface. ORDER FOR TIGHTENING Tighten the bolts in the order shown in the diagram on the right. After tightening, check that the nut and shoe are in close contact with the link mating surface.

4.9.1.g CHECK AND ADJUST TRACK TENSION (Machine equipped with road liner, steel shoe) The wear of the pins and bushings on the undercarriage will vary with the working conditions and type of soil, so inspect the track tension frequently in order to maintain the standard tension. Stop the machine on firm, horizontal ground when carrying out the inspection and maintenance. CHECKING 1. Run the engine at low idling, move the machine forward a distance equal to the length of track on ground, then stop the machine. 2. Choose wooden block (3) that will reach from idler (1) to carrier roller (2), then place it on top of the track. 3.

Measure the maximum deflection between the top surface of the track and the bottom surface of the wooden block. Standard deflection Deflection “a“ should be 5 to 15 mm (0.197 to 0.6 in.). If the track tension is not at the standard value, adjust it in the following manner. 180