Komatsu — 4.9.1.g CHECK AND ADJUST TRACK TENSION (Machine equipped with road liner, steel shoe)

MAINTENANCE PROCEDURE ADJUSTMENT WARNING There is danger of plug (1) flying out under the high in­ ternal pressure of the grease. Never loosen plug (1) more than 1 turn. Never loosen any part other than plug (1). Never put your face in the mounting direction of plug (1). If the track tension cannot be loosened with the proce­ dure given here, please contact your Komatsu Utility Dealer. INCREASING TRACK TENSION Prepare a grease gun. 1. Pump in grease through grease fitting (2) with a grease pump. 2. To check that the correct tension has been achieved, run the engine at low idling, move the machine slowly for­ wards (7 - 8 m), then stop the machine. 3.

Check the track tension again, and if the tension is not correct, adjust it again. 4. Continue to pump in grease until dimension S becomes zero (0). If the tension is still loose, the pin and bushing are excessively worn, so they must be either turned or re­ placed. Please contact your Komatsu Utility Dealer for re­ pairs. LOOSENING TRACK TENSION It is extremely dangerous to release the grease by any method except the procedure given below. If the track tension is not relieved by this procedure, please contact your Komatsu Utility Dealer for re- pairs. 1. Loosen plug (1) gradually to release the grease. 2. When loosening plug (1), turn it a maximum of one turn. 3.

If the grease does not come out smoothly, move the ma­ chine forwards and backwards a short distance. 4. Tighten plug (1). 5. To check that the correct tension has been achieved, run the engine at low idling, move the machine slowly for­ wards (7 - 8 m), then stop the machine. 6. Check the track tension again, and if the tension is not correct, adjust it again. 181 WARNING