MAINTENANCE PROCEDURE 4.9.3.c REPLACE FUEL FILTER CARTRIDGE Engine is at high temperature immediately after the machine has been operated. Wait for engine to cool down before replacing the filter. Do not bring fire or sparks near the fuel. Prepare a filter wrench Prepare for cloth. 1. Open the engine rear cover. 2. Spread the cloth beneath the filter cartridge. 3. Set handle (1) of the water separator to CLOSED position (A). 4. Using a filter wrench, turn filter cartridge (2) counterclock wise to remove it. If any fuel spills, wipe it up immediately with a cloth. 5.
Clean the filter holder, fill the new filter cartridge with fuel, then coat the packing surface with fuel, and install to the filter holder. 6. When installing, turn to the right to tighten until the pack ing surface contacts the seal surface of the filter holder, then use a filter wrench to tighten approx. 1 turn. Tightening torque: 19.6 to 23.5 Nm (2.0 to 2.4 kgf·m, 14.5 to 17.4 lb.ft.). 7. Set handle (1) of the water separator to OPEN position (B). 8. After replacing the fuel filter element, bleed air. For details of the procedure, see “Air Bleeding“. AIR BLEEDING 1. Fill the fuel tank with fuel. 2. Set handle (1) of the water separator to OPEN position (B). 3.
Loosen air bleed bolt (2) of the water separator 2 or 3 turns. 4. When no more bubbles come out with the fuel from air bleed bolt (2), tighten air bleed bolt (2). 5. Turn the starting switch to the ON position, hold it there for 10 to 15 seconds, then return it to the OFF position. Air bleeding is carried out automatically by the automatic air bleed device. NOTE When the machine has run out of fuel, carry out the same procedure, to bleed the air. 195 WARNING