MAINTENANCE PROCEDURE 4.9.3.d CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL The parts and oil are at high temperature immediately after the engine is stopped, and may cause seri ous burns. Wait for the temperature to go down before starting the operation. If there is still pressure remaining inside the case, the oil or plug may fly out. Loosen the plug slowly to release the pressure. Prepare a container to catch drained oil. Prepare a hexagon wrench. 1. Set so that plug (G) is at the top, with plug (G) and plug (P) perpendicular to the ground. 2. Set the container to catch oil under plug (P). 3. Remove plug (G) with a hexagonal wrench. Oil level shouldbe near the bottom of the plug hole (G).
4. If the oil level is low, add oil through the hole in plug (G) until the oil overflows. 5. After checking, install plug (G). 4.9.3.e CLEAN AND INSPECT RADIATOR FINS AND OIL COOLER FINS If compressed air, high-pressure water, or steam hit your body directly, or they cause dirt or dust to be blown up, there is a hazard of serious injury. Always use safety glasses, dust mask, or other protective equipment. IMPORTANT When use the compressed air, keep a distance from air nozzle, to prevents damage to the fins. To prevent damage to the fins, apply compressed air from and appropriate distance. Damaged fins may cause water leakage or overheating.
In a dusty site, check the fins daily, irrespective of the maintenance interval. 1. Open the engine rear cover and cooling cover. For de tails, see Section "3.2.10 COOLING COVER". 2. Use compressed air, steam, or water to blow off the mud, dirt, and leaves clogging radiator fins and oil cooler fins (1). 196 WARNING WARNING