Vehicle Access and Features Seat Belt Operation Three-Point Seat Belt with Komfort Latch WARNING Wear three-point seat belts only as described be- low. In case of an accident or sudden stop, injuries could result from misuse. Three-point seat belts are designed to be worn by one person at a time. 1. Before driving the vehicle, slowly pull the link end of the three-point seat belt out of the retractor and pull it across your lap (from outboard to inboard) far enough to engage the buckle. If the retractor locks too soon, allow the belt to retract slightly, then slowly pull it out again. 01/18/95 f910004a 2. Fasten the three-point seat belt by pushing the link into the buckle until it latches.
See Fig. 2.8 . Give the belt a tug at the buckle. If the buckle unlatches, repeat this step. If the problem continues, replace the three-point seat belt. Fig. 2.8, Fastening the Three-Point Seat Belt (typical) Pull on the shoulder strap to lessen the pressure of the strap on your shoulder and chest. Allow no more than one inch (2.5 cm) of slack between your chest and the shoulder harness. More slack can significantly reduce the seat belt’s effectiveness in an accident or a sudden stop. While holding the belt slack, press the Komfort Latch lever up, clamp- ing the belt’s webbing. See Fig. 2.9 and Fig. 2.10 . 3. Position the shoulder strap diagonally across your chest.
If desired, engage the Komfort Latch as fol- lows: 2.8