. MAINTENANCE MAINTENANCE INFORMATION Service Meter Reading Check the service meter reading every day to see if the time has come for any necessary maintenance to be performed. Komatsu Genuine Lubricants For lubrication of the machine, use the Komatsu genuine lubricants. Moreover use oil of the specified viscosity according to the ambient temperature.
4 - 2 MAINTENANCE INFORMATION Do not perform any i nspection and maintenance oper ation that is not fo Komatsu Genuine Re placement Parts Use Komatsu genuin e parts specified in the Parts Bo ok as replacemen Windshield Washer F luid Use automobile wind ow washer fluid, and be careful not to let any dirt g Fresh and Clean Lub ricants Use clean oil and gre ase. Also, keep the containers o f the oil and greas e clean. Keep foreig n materials a way from oil and grease. Check Drained Oil an d Used Filter After oil is changed o r filters are replaced, check the ol d oil and filters for m etal particles and for eign materia ls. If l arge quantity of metal pa suitable action.
rticles or foreign materials are found, always report to the person in charge, and carry out harge, carry Fuel Strainer Do not remove the s trainer from the filler port when a Welding Instructions Cut off power. Wa it for approx. one minute after tu rning off the engin e starting switch key , and then di sconnect the negative (-) te rminal of the battery. than 200 V continuously. g cable within 1 m (3.3 ft) of the area to be welded. If grounding cable is connected near ectors, etc., the instruments may malfunction. Do not apply more Connect groundin g cable within 1 m (3.3 instruments, conn ectors, etc., the instruments may malfunction.
If a seal or bearing happens to come between the p art being welded and grounding point, change the g rounding point to avoid suc h parts. a around the work equipment pins or the hydraulic cylinders as the grounding point. Do not use the are a around the work equipment pi ns or the hydraulic cylinders as the gro unding point Do not Drop Things I nside Machine When opening ins pection windows or the oil filler p ort of the tank to carry out inspection, be careful n ot to drop nuts, bolts, or tool If such things are lead to failure. If y s inside the machine.
dropped inside the machine, it ma y cause damage and/or malfunction of the machine , an d will ou drop anything inside the mac hine, always remo ve it immediately. r inspection. Do not put unnece ssary things in your pockets. C arry only things wh ich are necessary fo r inspection. Dusty Jobsite ty worksites, do as follows: When working at dus Inspect the dust in dicator frequently to see if the ai r cleaner is dirty o Clean the radiator core frequently to avoid cloggin g.