Komatsu — Full page photo print

. MAINTENANCE MAINTENANCE PROCEDURE CHANGE OIL IN ENGINE OIL PAN, REPLACE ENGINE OIL FILTER CARTRIDGE WARNING after the engine is stopped and may cause serious burns. Wait for the oil 4. Open the pump room on the right side of the machine, then using the filter wrench, turn filter cartridge (1) to the left to remove it. 4 - 59 Parts and oil are at hi gh temperature immediately temperature to go dow n before performing this ope Oil pan refill amo unt: 11 liters (2.91 US gal) Prepare a filter w rench 1. Remove underc over at the bottom of the m achine, then s et the container under drain valve (P) on the left side of the ma chine to catch the oil. 2. Loosen drain plu g (P) and drain the oil.

Be careful not to get oil on yourself. ug (P). 3. Tighten drain pl 5. Clean the filter h older, fill the new filter ca rtridge with cle an oil, coat the thread and pac king portion of the new filter cartridge w ith oil (or coat thinly with g rease), then i REMARK Check that there is n o old packing stuck to the filter holder. If there is an y old packing stuck to the filter, it will cause leakage of oil. 6. When installing, tighten until the packing s urface contac ts the filter holder, then tighten 7. After replacing t he filter cartridge, add oil through oil fill er (F) 8. until the oil level is between the H and L m arks on the di pstick (G).

Run the engine at idle for a short time, then stop the engine, and check that the oil level is between the H and L marks on the dipstick. For details, see "Check Oil Level in Engine Oil Pan, Add Oil (PAGE 3-116)".