Komatsu — Full page photo print

. MAINTENANCE MAINTENANCE PROCEDURE REPLACE FUEL PRE-FILTER CARTRIDGE WARNING position (S). 2. Set the container to catch the fuel under the pre-filter cartridge. 3. Loosen drain valve (2), then drain all the water and sediment in the transparent cap (3) and also the fuel accumulated in filter cartridge (4). 4. Using a filter wrench, turn transparent cap (3) to the left to remove it. (This cap is used again.) 4 - 60 After the engine has bee n operated, all parts are at high t emperature, so do not replace the filter im mediately. Wait for all parts to cool down before star ting the operation. ed inside the engine fuel piping system when the engine is running.

High pressure is generat ed inside the engine fuel piping system when t When replacing the filte r, wait for at least 30 seconds a fter stopping th e engine to let the intern al pressure go down before replacing the filter. lame close. Do not bring any fire or f NOTICE Genuine Komatsu fuel fi lter cartridges use a special filt er that has high ly efficient filtering abilit y. When replacing the filter cartridge, always use a g enuine Komatsu part. The common rail fuel inj ection system used on this ma chine c onsists o f more precise parts tha n the conventional injection pump and nozzle.

If any part other than a g enuine Komatsu filter cartridge is used, dust or dirt may get in and cause problems with the injection system. Always avoid u sing substitute parts. When carrying out inspe ction or maintenance of the fue l system , pay m ore attention than normal to the entry of dirt. If dirt is stuck to any part, use fu el to wash it off completely. Prepare a container t Prepare a filter wrenc 1. Turn the valve (1) at the bottom of the fuel tank t o the C 5. Using a filter wrench , turn cartridge (4) to the left to remove it. 6. Install transparent ca p (3) to the bottom of the ne w filter cartridg e. (When doing this, a lways replace O-ring (5).)