PACCAR 579, 567 — Sleeper Heater and Air Conditioner Controls (Optional)

CONTROLS - Heating and Air Conditioning distribution to maximize clearing of the windshield. The system will remain in this mode until the driver presses the button again or adjusts the dials. 3 1 3 2 The air temperature in MAX defrost mode will be set to the warmest temperature setting. This setting helps to clear the windshield of ice and fog more quickly. Outside air mode and the air conditioner compressor are also active to maximize performance. The A/C compressor and recirculation switches are disabled in MAX Defrost. 1. Air Speed 2. Compressor 3. Temperature Adjustment The temperature control is not keyed to specific temperatures. Turning counterclockwise means cooler than it is now.

Clockwise means warmer than it is now. Once the desired temperature is reached, the system will maintain it automatically. A separate switch on the dash HVAC unit will send power to the "bunk" or sleeper control unit The button on the cab HVAC unit must be pressed and in the ON mode to use the sleeper controls. Power to the sleeper HVAC unit can be toggled using the button inside the air distribution dial. When activated, the indicator on the button illuminates. The sleeper HVAC unit will function to the settings of the sleeper control. NOTE Sleeper Heater and Air Conditioner Controls (Optional) General information about the sleeper heater and air conditioner controls.

The sensor is located on the sleeper heater -A/C control panel and meas- ures the sleeper air temperature at the panel. There will be a time delay be- tween temperature control adjustment and sleeper air temperature change. Also, be careful of any heat source which could affect the air temperature by the sensor. Avoid hanging items (eg shirt, jacket, hats) which could block the air flow to the sensor Unlike the cabin air temperature controls, the sleeper temperature control will alter the air temperature based on the knob setting. 118 Y53-6047-2HEN (03/18) NOTE On the Cab Control Unit, the sleeper enable switch must be pressed to turn ON power to the sleeper control unit.

In addition, if air conditioning is re- quested in the sleeper, the air condi- tioner switch on the cab control unit will be turned ON and fan in the cab heater and air conditioning unit will be turn on low (if it was OFF) automatical- ly.