DRIVING - Transmission 5. Release the clutch pedal (manual only), then gradually accelerate to permit smooth starting. 6. Do not allow your vehicle to roll (even a little) in the opposite direction during clutch engagement. If you need to start up on an incline, apply your service brakes before you release the parking brake. Then release your service brakes as you engage the clutch and apply throttle. For further instructions on operating your transmission, see the transmission manufacturer's Driver/Operator's Instruction Manual. If you want to shift directly into any gear other than first or reverse, depress the clutch pedal only far enough to release the clutch.
Fully depressing the pedal applies the clutch brake and could cause gear hang-up. If you have a misaligned gear condition in your vehicle's transmission and cannot start, gradually release the clutch, allowing the drive gear teeth to line up properly. Then the drive gear can roll enough to allow the teeth to line up properly and complete the shift. The best engine performance and maximum economy is obtained if gears are properly selected. This efficiency is achieved by always selecting gears within optimum engine rpm, which is where maximum torque and power are obtained. Shift carefully in a new vehicle. The transmission may be a little stiff at first.
Avoid gear clashing, by closely following these procedures. When you are operating a new vehicle or one that has been exposed to cold weather, you want the transmission lubricant (fluid) to circulate and coat the contacting surfaces of the gears. Metal contacting metal in moving parts may seriously damage your transmission, do not drive in one gear for long periods of time until the transmission lubricant has a chance to coat all contacting surfaces. Always select a starting gear that will provide sufficient gear reduction for the load and terrain. Never downshift when the vehicle is moving too fast. Never slam or jerk the shift lever to complete gear engagement.
Never coast with the transmission in neutral and the clutch disengaged. How to Use the Hyrdaulic Clutch Certain vehicles have a hydraulic clutch to shift a manual transmission. CAUTION Be careful not to apply the clutch brake while the vehicle is moving. The purpose of the clutch brake is to stop the transmission so that you can shift into a starting gear without grinding gears. Applying the clutch brake when the vehicle is moving causes a braking effect on the drivetrain and shortens the service life of the clutch brake. 4 CAUTION Do not push the clutch pedal com- pletely to the floor when shifting while the vehicle is in motion.
using the clutch brake while shifting a vehicle in motion will damage the clutch brake. A non functioning clutch brake will make shifting very difficult when the vehicle is stationary. 1. Depress the clutch pedal past the first 1/2 inch (13 mm) for 142 Y53-6047-2HEN (03/18)