PACCAR 579, 567 — Automatic and Automated Transmissions

DRIVING - Transmission approximately 5 1/2 in (139.7 mm) of total pedal travel. 2. Depress the clutch pedal another 1/2 in (13 mm) to engage the clutch brake. Always use the clutch when making upshifts or downshifts. Never coast with the transmission in neutral and the clutch disengaged. To provide smooth gear engagements while shifting, use proper coordination between shift lever and clutch. a. a. Upshifts: let the engine and gears slow down to the rpm required for the next gear. b. b. Downshifts: press accelerator, increase engine and gear speed to the rpm required in the lower gear. 4.

Now quickly press the pedal to disengage the clutch and move the gear shift lever to the next gear speed position. 5. Release the pedal to engage the clutch. The clutch brake is used for stopping transmission gears, allowing you to easily shift into first gear or reverse without grinding gears. The clutch brake is not necessary when shifting into other gears while in motion. If the clutch pedal is pressed completely to the floor and the transmission is not shifting, then it is time to have the clutch adjusted or serviced. If the transmission has a butt-tooth condition and you cannot engage a gear, gradually release the clutch.

Then the drive gear can roll enough to allow the teeth to line up properly and complete the shift. The clutch is not a footrest. Do not drive with your foot resting on the clutch pedal. It will allow your clutch to slip, causing excessive heat and wear, damage could result. When you must idle your engine for any period of time, shift your transmission to neutral and disengage the clutch (take your foot OFF of the pedal). This helps prevent unnecessary wear to your clutch release bearing, and it is less tiring for you, too. How to Shift using Double Clutch Method Whether you are upshifting or down shifting, it is best to double clutch.

Double clutching is easier on the transmission and on the engine, helping your vehicle match engine speed with driveline speed and achieving clash-free shifts. 4 Automatic and Automated Transmissions An automatic or automated transmission makes shifting much easier. It remains important to completely understand how to operate the transmission to optimize its efficiency. Please read the manual for your automatic or automated transmission included with your vehicle. For automated transmissions, there is no "park" position. So you will need to apply the parking brake before leaving the cab. To double clutch: 1. Push the clutch pedal down to disengage the clutch. 2.

Move the gear shift lever to neutral. 3. Release the pedal to engage the clutch. This lets you control the rpm of the mainshaft gears, allowing you to match the rpm of the mainshaft gears to those of the output shaft. Y53-6047-2HEN (03/18) 143