PACCAR 579, 567 — Using the Manual - Automatic Button

DRIVING - Transmission Hill Hold Using the Manual - Automatic Button WARNING If your vehicle has an automated transmission, be aware that it can roll backwards when stopped on a hill or grade, or when starting from a stop on a hill or grade. Failure to comply may result in death, personal injury, equip- ment or property damage. Observe the following guidelines: (1) When stopped on a hill or grade, press the brake ped- al. (2) When starting from a stop on a hill or grade, quickly remove your foot from the brake pedal and firmly press on the accelerator pedal. The hill hold feature is available as an option with certain automated transmissions.

This feature holds the vehicle while on a hill to allow the operator to release the service brakes and press the accelerator. This feature will hold the vehicle if the vehicle is attempting to go up a hill from a stop in either drive or reverse. 4 Controls for Vehicles with an Eaton Automated or a PACCAR Transmission This vehicle may be equipped with either an Eaton Automated or a PACCAR Transmission. The Automated or PACCAR Transmission controls are located on the right hand side of the steering column. WARNING This button will put the transmission into manual mode. Manual mode will allow the operator to select the gear. See Up or Down Shifting on page 145.

To activate, put the gear selector in the D (drive) mode and then depress the M/A button. The instrument cluster will display the corresponding selection. Do not leave the cab of your vehicle without applying the parking brake. The truck could roll and cause an acci- dent resulting in death or personal in- jury. Always apply the parking brake before you leave the cab. 144 Y53-6047-2HEN (03/18)