DRIVING - Axle and Suspension under heavy loads or rough terrain as well as for over the road hauling. can drive with the axle in the LOW or HIGH range. Always UNLOCK the inter-axle differential before shifting the axle speed range. wheel speed. When you shift the axle, the connection between the engine and wheels is momentarily disengaged while the gearing is synchronized. Normally when the axle is shifted the speed of the engine, axle, and wheels adjust, allowing for proper gear engagement. When going downhill the wheels will not slow down, but will tend to speed up, which makes gear synchronization almost impossible.
As a result, the axle is neither in HIGH nor LOW range and all engine/ driveline retardation is lost. Without engine retardation it is more difficult to slow the vehicle down and greater stress is put on the brake system. The Low Range provides maximum torque for hauling heavy loads or traveling over rough terrain. The High Range is a faster ratio for highway speeds and general over the road conditions. A switch on the accessory switch panel controls the Dual Range Rear Axle. You will notice that the switch has a guard to protect you from activating it accidentally. Always park your vehicle with the range selector in LOW.
Important tips on operating a Dual Range Axle with Interaxle Differential: Shift the axle with the inter-axle differential in the unlocked position only. When you are driving with poor traction, lock the differential. When you have the differential locked, drive with the axle in LOW range only. When you are driving on a surface with good traction, keep the interaxle differential unlocked. You WARNING Never shift the axle when moving downhill. Engine driveline disengage- ment may occur, eliminating engine re- tardation and allowing the wheels to spin faster than the current speed of the engine. This may require severe braking to slow the vehicle down and can result in an accident.
Failure to comply may result in death, personal injury, equipment or property damage. 4 CAUTION CAUTION To avoid damaging your vehicle shift the axle at slower travel speeds until you are used to driving with a dual range axle. If you shift the axle range with the in- ter-axle differential in LOCK, you could seriously damage the axles. Never shift the axle range with the differential locked. How to Operate Two Speed Axle - Low to High These steps should be used if operating a 2 speed axle in LOW range on rough Proper shifting of the axle depends on the synchronization of engine/driveline and Y53-6047-2HEN (03/18) 157