PACCAR 579, 567 — Air Suspension Ride Height

DRIVING - Axle and Suspension joint working angles. This can result in pre- mature driveline wear and driveline vibration. If it becomes necessary to reset the ride height, you may temporarily set it by following the next procedure. Proper ride height measurement and values are shown in the illustration and table below. suspension. Measure the ride height from the bottom of the frame rail to the approximate centerline of the rearmost drive axle hub: For tandem axles, make the vertical measurement at the centerline of the suspension For a single axle, make the measurement in front of the axle, in the area forward of the tires but not past the suspension bracket. 7.

When at the correct ride height, ensure that the height control valve lever is in the neutral position, then install either the built-in alignment pin or a 1/8-inch (3 mm) dowel. 4 CAUTION Completing this procedure will enable you to safely reach the nearest author- ized dealer or repair facility to have ride height and pinion angle reset us- ing the proper equipment and techni- que. Do this as soon as possible to avoid potential driveline damage. 3. Ensure that the tractor is fully laden during this procedure. Do not use these procedures on a vehicle that is not laden (bobtail). 4.

Ensure the air supply and delivery plumbing of the height control valve is consistent with the following illustrations. 5. Loosen the fasteners mounting a height control valve to its bracket. NOTE Suitable wheel chocks are at a mini- mum an 18-inch (46 cm) long 4x4. 1. Park the vehicle, engage the parking brakes and clock the wheels. 2. Locate the air suspension ride height valve 8. Torque the mounting fasteners to 55-75 lb-in (6.2-8.5 Nm.). 9. Remove the alignment pin or dowel. 6. Rotate the valve either clockwise or counterclockwise until air pressure in the air springs provides the ride height specified for that 162 Y53-6047-2HEN (03/18)