PACCAR 579, 567 — Air Suspension Ride Height

DRIVING - Axle and Suspension weight limits and obtain the proper load distribution. desired load or load range is achieved, document the pressure-to-load ratio or setting for future use. ground loading with the weight scale. Perform this procedure at or near a weight scale. Procedure can be performed while parked on the weight scale if scale is available. To obtain the desired axle load distribution, you must correlate the suspension air gauge pressure to the actual axle load by scaling the axle weight(s) and adjusting the pressure to obtain the desired load. Once the desired load or load range is achieved, document the pressure-to-load ratio or setting for future use.

These instructions are general in nature. For more specific instructions, review the pusher or tag suspension manufacturers maintenance manual or contact the nearest authorized dealer. 1. Park loaded vehicle on level surface with wheels blocked. 2. Release vehicles spring brakes. (Do not release for Liftable/Non- Steerable pusher or tag axles). 3. Lower the pusher/tag axles with the axle lift control flip valve. (For some non-liftable axles, inflate air suspension). 4. Adjust the amount of load on each axle by turning the pressure regulator clockwise to increase the load or counterclockwise to decrease the load.

(The suspension manufacturer may publish pre-established Pressure- to-Load Ratio Pressure Settings to assist you in achieving an estimated ground load). 5. After setting the pressure to obtain the desired axle load, verify proper NOTE Exceeding local, state or federal weight limits may result in citations. Contact your local commercial weight enforcement office for limits in your area. 4 NOTE Steerable-pusher and/or tag axle(s) will raise when the transmission is shifted into reverse or when the park- ing brakes are applied. NOTE This procedure must be performed pri- or to placing the vehicle into service.

Air Suspension Ride Height Information on air suspension and adjusting the ride height. Add: Perform this procedure at or near a weight scale. Procedure can be performed while parked on the weight scale if scale is available. Vehicles equipped with rear or front air suspensions have their ride height and axle (pinion) angle(s) preset at the factory. These are precision settings and should not be altered.

Incorrectly adjusted ride height may result in improper interaxle U- Setting the Pressure-to- Load Ratio To obtain the desired axle load distribution, you must correlate the suspension air gauge pressure to the actual axle load by scaling the axle weight(s) and adjusting the pressure to obtain the desired load. Once the Y53-6047-2HEN (03/18) 161