MAINTENANCE - Maintenance Schedule 5 182 Y53-6047-2HEN (03/18) System Component Task I A B C D E Drive Axle (Dana) Magnetic Drain Plug and Breather (ON HIGHWAY) Clean or replace. • Magnetic Drain Plug and Breather (OFF HIGHWAY) Clean or replace. • Drive Axle (Meritor Line Haul / ON HIGHWAY) Axle Housing Check the "cold" fill level at the differential carrier plug for a pinion angle of less than 7 degrees, or at the axle bowl plug for a pinion angle of greater than 7 degrees. Tighten the plug to 35-50 lb-ft (47-68 Nm) • Visually inspect for damage or leaks.
• Drain and replace the lubricant See Rear Axle Lubrication on page 257 Lubricant Filter Change the filter • Breather Check the operation. If the cap doesn’t rotate freely, replace. • Input Shaft and Pinion Shaft Check and adjust the endplay. • Axle Shaft Tighten the rear axle flange nuts to the specified torque value. • Interaxle Differential Check the operation. •