MAINTENANCE - Maintenance Schedule 5 Y53-6047-2HEN (03/18) 183 System Component Task I A B C D E Drive Axle (Meritor City Delivery / OFF HIGHWAY) Axle Housing Check the "cold" fill level at the differential carrier plug for a pinion angle of less than 7 degrees, or at the axle bowl plug for a pinion angle of greater than 7 degrees. Tighten the plug to 35-50 lb-ft (47-68 Nm) • Visually inspect for damage or leaks. • Drain and replace the lubricant. See Rear Axle Lubrication on page 257 Lubricant Filter Change the filter • Breather Check the operation. If the cap doesn’t rotate freely, replace. • Input Shaft and Pinion Shaft Check and adjust the endplay.
• Axle Shaft Tighten the rear axle flange nuts to the specified torque value. • Interaxle Differential Check the operation. •