PACCAR 579, 567 — How to Add Coolant to the Cooling System

MAINTENANCE - Cooling System Maintenance level in the tank is below the line marked MIN . How to Add Coolant to the Cooling System Add coolant through the surge tank fill cap. Do not remove the pressure cap to fill the cooling system. NOTE The minimum fluid level is determined by the line on the surge tank indicated by the letters "MIN". This indicator is located below the fill cap. The cooling system will need fluid if the surge tank level does not rise to the "MIN" line regardless if the system is hot or cold. Do not overfill a cooling system. Ex- cess coolant may result in overflow, loss of antifreeze, and reduced corro- sion protection. WARNING 1.

If your cooling system is built with drain valves in the upper engine coolant pipe, open them before filling the surge tank. 2. Close any open coolant drains in the system. 3. Remove the surge tank fill cap (do not remove the surge tank pressure cap). 4. Fill the system with premixed coolant through the surge tank fill cap. Pour coolant at a steady flow rate until the surge tank is full (to the base of the fill neck). It may be necessary to pause for 1 minute and then re-fill if the fluid level dropped. 5. Close any drain valves that were opened in Step 1. 6. Start the engine and idle at low rpm. Do not remove the radiator fill cap while the engine is hot.

Scalding steam and fluid under pressure may escape. You could be badly burned. Failure to comply may result in death or personal injury. 5 NOTE If frequent topping off is necessary and there are no visible signs of coolant leaks when the engine is cold, check for leaks with the engine operating at normal temperature. 1. Fill location 2. Fill line NOTE Do not use the pressure cap to fill the surge tank with fluid. 226 Y53-6047-2HEN (03/18)