MAINTENANCE - Cooling System Maintenance 7. During low rpm idle, air will purge from the cooling system which will lower the coolant level in the surge tank. Continue to fill the surge tank until the coolant level remains approximately Ѕ in. above the "MIN" line. This may take up to 2 minutes, depending on the outside temperature. 8. Operate the engine throttle until the operating temperature stabilizes (when the thermostat opens). 9. Fill the surge tank as necessary to raise the coolant level to Ѕ in. above the "MIN" level. 10. Operate the engine at high idle for another 10 minutes and then fill the surge tank again to Ѕ" above the "MIN" level. 11. Replace the surge tank fill cap.
Check the coolant level after each trip. Add coolant as necessary. You may find your coolant level is not up to the correct level soon after you have filled the radiator. This may be because all the trapped air in the system has not yet been purged. It takes a little time for all of the air to leave the system after you fill your radiator. Use a solution of half ethylene glycol antifreeze and half water for best heater performance. Do not use more than 65 percent concentration of antifreeze, as a shortened heater life will result. After servicing the cooling system, operate the vehicle for a day or two before using the heater. Trapped air inside the engine needs time to escape.
no extender added. The change interval is 1,000,000 miles (1,600,000 km)/20,000 hours/8 years with an extender addition at 500,000 miles (800,000 km)/10,000 hours/4 years. Nitrite-Free Extended Life Coolant Extended Life Coolant Information on using Extended Life Coolant (ELC). Nitrite-free organic acid technology coolant (OAT) may be used if it meets DAF 74002. The change interval for nitrite free coolant is 600,000 miles (1,000,000 km) or 6 years, with no extender needed. DO NOT add coolant extender to nitrite-free coolant. Follow the coolant supplier's drain/flush/fill/ diluting percentages when servicing a vehicle filled with nitrite-free coolant. Additional Recommendations:
Antifreeze is essential for freeze, overheat, and corrosion protection. The use of supplemental coolant additives (SCAs) is not recommended for extended-life coolants. Perform these maintenance procedures according to the Preventative Maintenance Schedule. Conduct coolant maintenance checks including freeze point, pH, nitrite and carboxylate tests at least twice annually to maintain engine protection. 5 Nitrited Extended Life Coolant For nitrited formulations (NOAT), a heavy- duty extended life coolant that meets ASTM D6210 and Caterpillar EC-1 specifications must be used.
The change interval for extended-life coolant containing nitrite and molybdate is 750,000 miles (1,200,000 km) or 12,000 hours of on-road use (8 years or 15,000 hours of off-highway use) on initial fill with Recommended Extended Life Coolant Suppliers Authorized PACCAR Engine dealer ® Y53-6047-2HEN (03/18) 227