MAINTENANCE - Engine Maintenance 5. Remove the single bolt (with a 13 mm wrench) that holds the solenoid to the filter housing. WARNING Do not disconnect any lines at the sol- enoid body. They could be pressurized which may result in personal injury. 9. Verify that there are no air leaks, start the engine and allow the air system to reach operating pressure. Activate the under hood air switch and verify that there are no air leaks. Disconnecting the air solenoid will allow the air cleaner housing to be removed to access the air filter. 5 6. Cover the air hose end and the fitting with tape or something lint free to keep airline free from debris.
Replace Engine Air Filter Maintenance information about servicing the engine air intake filter. 7. To reinstall the air solenoid, tighten the 13 mm bolt to 70 ± 5 in- lbs. 8. To reinstall the air line to the solenoid, push the air hose into the fitting then pulling on the air hose to ensure that it is properly seated. If the vehicle has under hood air intake option, remove the air solenoid first. 244 Y53-6047-2HEN (03/18)