MAINTENANCE - Engine Maintenance drop or tap the filter on the housing during removal as this could loosen dirt and dust trapped in the filter. DO NOT clean and reuse the original filter. 6. Inspect the sealing surface and clean out any debris from the air filter housing and enclosure before installing a new filter. Be careful to not push any contaminant into the engine inlet. 7. Visually inspect the new filter and the filter housing for damage, especially the sealing surfaces and filter media. 8. Install the filter housing. DO NOT use the housing to drive the filter into position. Tighten screws to 30 lb-in ± 5 (3.4 N·m ± 0.56). 9.
Start the engine and allow the air system to reach operating pressure. Activate the under hood air switch and verify that there are no air leaks. pack is installed to keep burning embers from entering the air filter. Engine Air Intake Filter Module NO STEP NO STEP 2 3 2 3 Maintenance is required to ensure proper performance of the pack. At each engine intake filter change, remove these packs and clean them with water. Be sure to rinse with water in opposite direction of normal air flow. How to remove the ember pack: 1. Remove the 7 M6 fasteners using an 8 mm wrench. 1 1 PACCAR 4 1. Main enclosure 2. Air filter 3. Housing 4. Screws 5 1. Park the vehicle.
Set the parking brake and turn the ignition OFF. 2. If air intake is located under the hood, open hood. 3. Loosen the (4) screws, with a 10 mm wrench, that hold the housing to the main filter enclosure. (These screws will not come out of the housing.) 4. Pull the air filter housing away from the main enclosure to access the filter. 5. The filter can be removed by gently pulling directly out of the main enclosure. Be careful not to 2. Pull the pack away from the hood until the outboard hooks clear the opening. Ember Packs (Optional) Certain vocational models will have an Ember pack on either side of the hood rather than the air pre-cleaner. This ember Y53-6047-2HEN (03/18) 245