PACCAR 579, 567 — Frame

MAINTENANCE - Frame your truck, observe the following precautions before welding: Disconnect all electronic devices. It is not possible to list all of the electronics that could be affected, but a few examples include the following: alternator, engine Electronic Control Unit (ECU), transmission ECU, ABS ECU, navigation devices, diagnostic devices, and monitoring devices. Disconnect battery cables and insulate them from the vehicle. Do not use the ECU or engine ground stud for the ground of the welding probe. Ensure that the ground connection for the welder is as close to the weld point as possible.

This ensures maximum weld current and minimum risk to damage of electrical components on the vehicle. CAUTION comply may result in death, personal injury, equipment or property damage. If anyone ever pours gasoline into your fuel tank, drain the entire system. Oth- erwise, the pump and engine will be damaged. Don’t try to dilute the gaso- line by adding diesel fuel (See Warn- ing above). WARNING Frame welding is NOT recommended. The high heat of welding nullifies the special heat treatment of the rails, greatly reducing the tensile strength of the frame rail.

If a frame member be- comes cracked from overloading, fati- gue, surface damage or a collision, the only permanent repair is to replace the damaged frame member with a new part. Fuel Filters See Engine Manufacturer’s Operator Manual provided with this chassis. 5 Frame Emergency Welding WARNING In an emergency, a temporary repair may be performed. Observe the following precautions to protect electronic systems during welding operations. Emergency welding procedures are further explained in the maintenance manuals. Please refer to the ordering information on the back cover to obtain a maintenance manual.

In the event of emergency welding of a frame rail and when welding any other part of your truck or any component attached to Do not cut, splice or weld frame rails or drill through the top or bottom flang- es of the rails. These operations could affect frame rail strength leading to a failure resulting in an accident. Rail failures resulting from such modifica- tions are not warrantable. Failure to Painting Do not electrostatically paint your truck or any component on your truck without first removing all of the electronic components from the truck. It is not possible to list all of the electronics that could be affected, but a Y53-6047-2HEN (03/18) 247