PACCAR 579, 567 — Power Steering Fluid Filter

MAINTENANCE - Steering System the power assist system goes out, steering the vehicle is still possible, yet it will require much greater effort. Visually check the following parts: Crosstube: Is it straight? Draglink tube clamp: Check for looseness or interference. Ball joints and steering U-joints: Check for looseness. Steering wheel for excessive free- play. Check the simplest probable causes first: a. unequal tire pressures b. loose cap nuts c. bent crosstube d. lack of lubrication. If these checks do not reveal the problem, or if you correct them and still have a steering problem, take your truck to an authorized dealer for evaluation. point between Maximum and Minimum level indicators.

If you check the fluid with the engine and steering system WARM, the fluid should NOT exceed the Maximum level indicator and should generally not drop below the middle point between the Maximum and Minimum level indicators. due to incompatible additives. Mixing incompatible fluids may lead to equip- ment damage. NOTE Before removing reservoir cover, wipe outside of cover so that no dirt can fall into the reservoir. Check and completely change the fluid level. Use the following procedure: 1. Park the vehicle on level ground and turn the engine off. 2. Open hood 3. Open the fill cap to the power steering reservoir.

In addition to the reservoir itself, the cap has a dipstick that indicates fluid level when the fluid is hot and when it is cold. Each of the conditions have a MAX and a MIN mark. If you check the fluid with the engine and steering system COLD, the fluid level should be at/or above the Minimum indicator level and should generally not exceed the middle Power Steering Fluid Filter The power steering system has a filter that needs to be maintained. 5 CAUTION Servicing the power steering system without bleeding it of trapped air may cause damage to the power steering pump. Power Steering Fluid Have the power steering fluid and filters changed at an authorized dealer. CAUTION 1.

Park the vehicle and turn the engine off 2. Open the hood and locate the power steering filter housing 3. Open the housing by taking off the top of the housing 4. Replace the filter When adding fluid, be sure to use fluid of the same type. While many fluids have the same description and intend- ed purpose, they should not be mixed Y53-6047-2HEN (03/18) 259