PACCAR 579, 567 — Driveline

MAINTENANCE - Driveline 5. Replace the fluid 6. When adding new fluid, bleed the power steering system by turning on the engine and turning the steering wheel full right and then full left. Add fluid when necessary as air bleeds out of the system. Pitman Arm Clamp Bolt Driveline General lubrication information for drivelines. See the driveshaft manufacturer's operator's manual for lubrication specifications and service intervals. Steering Shaft Bolt Torque Specifications Fastener torque specifications for steering shaft. WARNING 5 WARNING Improper lubrication of U joints can cause them to fail prematurely. The driveshaft could separate from the ve- hicle and result in an accident.

Make sure lubricant is purged at all four ends of each U joint and loosen caps if nec- essary. Also, regularly inspect U joints for excessive wear or movement, and repair or replace as necessary. Failure to comply may result in death, person- al injury, equipment or property dam- age. For off–highway vehicles, tighten the U– bolts after the first day or two of operation. Then check weekly. The following are common torque specifications for most steering shafts. If this chassis is equipped with an electronic stability control (ESC) and is modified (e.g.

adding or removing an axle, converting from a truck to a trac- tor, converting from a tractor to a truck, changing the body, lengthening of the wheelbase and/or frame, relocating frame components, or modifying pneu- matic or electrical ABS/ESC harness- es) the ESC must be disabled by a qualified technician. If you have any questions, contact your authorized dealer. Failure to comply may result in death, personal injury, equipment or property damage. Steering U-joint Pinch Bolt 260 Y53-6047-2HEN (03/18) Fastener Size Tightening Specification ft-lb (N•m) 3/4 inch 300-320 (406-433) Fastener Size Tightening Specification ft-lb (N•m) 7/16 inch 55-60 (74-81)