. MAINTENANCE SERVICE PROCEDURE EVERY 1000 HOURS SERVICE Maintenance for every 50, 250 and 500 hours should be carried out at the same time. REPLACE FUEL MAIN FILTER CARTRIDGE WARNING Prepare a filter wrench After replacing the fuel pre-filter cartridge, replace the fuel main filter cartridge. 1. Place a container under the filter cartridge to catch the fuel. 2. Using a filter wrench, turn filter cartridge (1) counterclockwise on remove it. 3. Clean the filter holder, coat the packing surface of the new filter cartridge thinly with oil, then install the filter cartridge to the filter holder. NOTICE Do not add fuel to the fuel main filter cartridge.
4 - 66 After the engine has been operated, all parts are at high temperature, so do not replace the filter immediately. Wait for all parts to cool down before starting the operation. ine is running. High pressure is generated inside the engine fuel piping system when the eng When replacing the filter, wait for at least 30 seconds after stopping the engi ne to let the internal pressure go down before replacing the filter. Do not bring any fire or flame close. NOTICE Genuine Komatsu fuel filter cartridges use a special filter that has highly effic ient filtering ability. When replacing the filter cartridge, always use a genuine Komatsu part.
The common rail fuel injection system used on this machine consists of more precise parts than the conventional injection pump and nozzle. If any part other than a genuine Komatsu filter cartridge is used, dust or dirt ma y get in and cause problems with the injection system. Always avoid using substitute parts. When carrying out inspection or maintenance of the fuel system, pay more atte ntion than normal to the entry of dirt. If dirt is stuck to any part, use fuel to wash it off completely. 4. When installing, tighten until the packing surface contacts the seal su rface of the filter holder, then tighten it 3/4 of a turn.
If the filter cartridge is tightened too far, the packing will be damaged filter cartridge is too loose, fuel will also leak from the packing, so alw When tightening with a filter wrench, be extremely careful not to d and this will lead to leakage of fuel. If the ays tighten the correct amount. ent or damage the filter. 5. Fill the fuel tank with fuel. 6. After completing the replacement of fuel filter cartridge (1), bleed the a ir from the circuit. For details, see "BLEED AIR FROM FUEL CIRCUIT (PAGE 4-34)". Do not loosen the plug at the filter stand of the fuel prefilter. If it is loo sened, air is not bled.