. MAINTENANCE SERVICE PROCEDURE REPLACE CORROSION RESISTOR CARTRIDGE WARNING is no leakage of water from the filter seal 4 - 68 All th e engine parts are at high temperature aft er the engi ne has been operated, so never replace the ca rtridge immediately after finishing operations. Wait for the oil to cool down before replacing t he cartridg Prepare a filter wr 1. Set valve (1) at th e top of the corrosion resistor t o the CLOSED position, to close 2. Set the containe r to catch the water u nder the c 3. Using a filter wre nch, remove cartridg e (2). 4. Clean the filter h older, coat the steel cartridge with cle an engine oil, then i nstall i 5.
When installing, tighten until the g asket contacts seal l surface of the filt er holder, then tighte n a furthe r 2/3 turns If the filter cartri dge is tightened too far, the gask et wil damaged and thi s will lead to leakage of water. If the f ilter i s too oose, water will a lso leak from the gap at the gasket, so always tighten the corre 6. Set valve (1) to t he OPEN position to open 7. After replacing t he cartridge, start th heck that surface. If there i s any leakage of wa ter, check the ti ghtening of