. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN HYDRAULIC TANK WARNING and may cause burns. Wait for the NOTICE Do not use air pressure or oil pressure to carry out high-pressure greasing. 4 - 85 EVERY 4000 HOURS Maintenance for every 50 , 250, 500, 1000 and 2000 hour s service should b e carried out at the s temperature to go down b efore starting the work. When removing the oil fill er cap, turn it slowly to release the i ntern al pressure, the Refill capacity: 180 lite 1. Lower the dump body and stop the engine 2. Turn the cap of oil fi before removing the 3. Taking care not to ge drain the oil, then tigh 4. Pour in the specified amount of engine oil f rom o il fille r (F) 5.
After adding oil, chec k that the oil is at the specified le vel. For details of the oil t o use, see "CHEC K OIL HYDRAULIC TANK, ADD OIL (PAGE 3-76)". LUBRICATE FAN PUL LEY p, pump in grease through the grease ws. 1. 2. 3. 1. Stop the engine. Using a grease pum fittings shown by arro After greasing, wipe off any old grease that was pushed out.