OPERATING MACHINE Warming Up Operation The normal operating temperature of hydraulic oil is between 50 and 80 °C (122 and 176 °F). Hydraulic components may be seriously damaged if the machine is operated when the hydraulic oil temperature is below 20 °C (68 °F). Before starting work, be sure to follow these warm-up procedures until the temperature of the hydraulic oil reaches above 20 °C (68 °F). Warm-Up Procedures: 1. Run the engine at 100 to 200 minЇ№ (rpm) above slow idle speed for 5 minutes. 2. With the engine speed control lever or the engine speed control dial at the medium position, run the engine for 5 to 10 minutes. 3.
Extend and retract each cylinder several times and lightly operate the swing and travel motors to warm them up. Warming Up in Cold Weather IMPORTANT: In case the hydraulic oil temperature is low, never operate the machine until all actuator speeds become normal after warming up operation. 1. Run the engine at intermediate speed for 5 minutes 2. Do not run the engine at either slow or fast speed during (longer if the air temperature is extremely low). this time. 3. Extend and retract each cylinder several times and lightly operate the swing and travel motors to warm them up. 4. Extend the bucket cylinder to the stroke end.
Be sure not to hold the bucket lever in this position for more than 30 seconds. 5. Retract the bucket cylinder to the other stroke end. Be sure not to hold the bucket lever in this position for more than 30 seconds. 6. Repeat steps 4 to 5 until the bucket cylinder cycle time becomes normal. 5-10