OPERATING MACHINE Grading Operation Use the blade for soil refilling and general grading operations after excavation. Grading operation can be also performed by operating the boom, arm, and bucket simultaneously. IMPORTANT: When grading the ground with the bucket, do not pull or push dirt with the bucket while traveling the machine like a bulldozer. Every part of machine may receive excessively large loads, possibly resulting in damage to the machine. When Grading by Operating the Boom, Arm, and Bucket Simultaneously: M1M7-05-012 1. When grading from the forward to the backward, slowly roll in the arm while slightly raising the boom.
As soon as the arm passes the vertical position, slowly lower the boom so that the bucket can be horizontally moved. 2. When grading from the backward to the forward, operate the arm and bucket rolled back, as shown. Grading a slope surface can be performed by operating the machine in the same method as mentioned above. Avoid Driving Bucket Teeth into Ground d WARNING: If the bucket teeth are forcedly driven WRONG into the ground, crushed material may spatter, possibly resulting in injury of the operator and/or co-workers around the machine. Furthermore, the service lifetimes of all front attachment parts may be shortened.
If the bucket teeth are forcedly driven into the ground, the service lifetime of all front attachment parts (especially the bucket) may be severely shortened. When excavating tightly fastened gravelly soil, use the bucket digging out force. Operate the boom, arm, and bucket simultaneously so that the bucket teeth can be effectively penetrated into the excavation surface. Carefully operate the machine to prevent crushed material from spattering, possibly resulting in injury to the operator and/or co-workers around the machine.
WRONG Avoid Abusive Operation If digging force is increased by driving the machine while pushing the bucket into the ground, or by raising the rear of the machine to apply the machine weight to the bucket teeth, severe machine damage may result due to excessive overloading. M1M7-05-013 5-12