OPERATING MACHINE Precautions for Crusher Operation Before installing a hydraulic crusher on the machine, machine stability, and the hydraulic pressure and flow rate to operate the hydraulic crusher must be checked. Consult your authorized dealer for selection of the hydraulic crusher model to be installed. Refer to the Crusher Operation Manual for operation of the hydraulic crusher. Observe the following instructions to prevent the base machine and the hydraulic crusher from being damaged. Precautions for Hydraulic Crusher Operation d WARNING:
When the hydraulic crusher is used in M107-05-046 demolition work, machine stability is reduced as the crusher attachment is much heavier than the bucket. In addition, soil, broken pieces of rock or metals may be scattered during crusher operation, potentially creating hazardous situation. Take protective measures to prevent machine tipping over and/or scattering of hard materials and observe the precautions described below to ensure safe operation. M107-05-047 Do not raise the base machine off the ground with the bucket cylinder fully retracted or extended. Damage to the front attachment may result. In particular, avoid operating the machine with the bucket cylinder fully extended.
The bucket cylinder may easily become damaged under this condition. Use extra care to prevent the bucket cylinder from being damaged during demolition work of structure foundations. Operate the crusher over the front or rear side of the machine. Operating the breaker over the side of the machine will reduce machine stability, possibly resulting in tipping over of the machine. Do not raise the base machine off the ground with the arm cylinder fully extended. The arm cylinder may easily become damaged under this condition. When a heavyweight attachment such as a crusher is installed, avoid quickly starting or stopping the front attachment.
Failure to do so may result in damage to the front attachment. Operate the hydraulic excavator carefully to avoid hitting the boom and cab. Watch Out! Take care not to hit the boom and cab with the crusher. M1G6-05-009 5-23