hitachi — Hitachi ZX14-3/ZX16-3/ZX18-3/ZX27-3 Hydraulic Excavator Operator's Manual

TRANSPORTING Unloading d WARNING: Always travel the machine slowly. Press the travel mode switch toward the TURTLE side. Steering on a ramp may create a danger of tipping over. Never attempt to change travel direction on a ramp, possibly causing the machine to become unstable. If steering is unavoidable, first move back to the ground, modify traveling direction, and begin to drive again. The top end of the ramp where it meets the flatbed, there is a sudden bump. Slowly drive over it. Use extra care when rotating the upperstructure on the flatbed to prevent possible injury from machine tipping.

Slowly rotate the upperstructure with the arm fully rolled in under the boom to maintain the good machine stability. IMPORTANT: During unloading operation, maintain the angle between the boom and the arm at 90 to 110°. If the machine is unloaded with the arm fully rolled in, damage to the base machine may result. 1. Before moving the machine from the flatbed rear end to the ramp, position the front attachment so that the angle between the boom and the arm becomes into the range of 90 to 110°. While allowing the bucket to be contacted on the ground, slowly move the machine. IMPORTANT:

When moving the machine over the end of the flatbed onto the ramp, take care not to allow the bucket to come into contact with the ground. Damage to the hydraulic cylinders may result. 2. Do not lift the bucket off the ground until the machine is completely moved onto the ramp. 3. Slowly move the machine forward while raising the boom and arm gradually until the machine is completely off the ramp. 6-4