TRANSPORTING Lifting Machine with Crane d WARNING: Do not lift the machine with anyone riding on the machine. ZX14-3 : 3360 mm ZX16-3 : 3240 mm ZX18-3 : 3240 mm ZX14-3 : 2960 mm ZX16-3 : 2960 mm ZX18-3 : 2960 mm Use wire ropes and shackles strong enough to support the weight of the machine. Be sure to set the blade position with the engine running. Failure to do so may cause the blade to be moved from the set-position when lifted with a crane. ZX14-3 : 1100 mm ZX16-3 : 1100 mm ZX18-3 : 1100 mm 1. Swing the upperstructure so the blade is positioned at the front. (ZX27-3 only: Fully retract the blade cylinder.) 2. Fully extend the boom, arm and bucket cylinders, as illustrated to the right.
Pull the pilot control shut-off lever to LOCK position. TOPS Canopy M1NC-06-003 3. Position the boom straight ahead of the upperstructure. Apply the boom swing pedal lock. 4. Attach shackles to the boom and canopy (cab) hooks. Securely thread wire ropes through the shackles. ZX14-3 : 3140 mm ZX16-3 : 3020 mm ZX18-3 : 3020 mm ZX14-3 : 2760 mm ZX16-3 : 2760 mm ZX18-3 : 2760 mm 5. Slowly lift the machine so that shock loads will not be applied to the machine. Take sufficient care not to lose the balance of the machine. ZX14-3 : 1100 mm ZX16-3 : 1100 mm ZX18-3 : 1100 mm ROPS Canopy M1NC-06-001 ZX14-3 : 3140 mm ZX16-3 : 3020 mm ZX18-3 : 3020 mm ZX14-3 : 2710 mm ZX16-3 : 2700 mm ZX18-3 :
2700 mm ZX27-3 : 2560 mm ZX27-3 : 4450 mm ZX14-3 : 1100 mm ZX16-3 : 1100 mm ZX18-3 : 1100 mm ZX27-3 : 1440 mm ROPS Cab ROPS Cab ZX27-3 ZX14-3, 16-3, 18-3 M1NC-06-004 M1NC-06-002 6-5