MAINTENANCE 4. Rotate the hexagon section on the bottom of filter case (6) counterclockwise using a tool such as a wrench to remove filter case (6) from head cover (5). 5. While rotating filter element (7), pull to remove filter element (7) downward. 6. Replace O-ring (8) with a new one. 7. Securely install O-ring (8) in the O-ring groove on head cover (5). 8. Coat the seal on new filter element (7) with clean hydraulic oil. Completely install filter element (7) into filter head (4) while rotating filter element (7) taking care not to damage the filter element. 6 4 M1NC-07-010 5 9. Take care not allow dust and/or water enter the filter case. 10.
Install case (6) into head cover (5) while rotating the case clockwise. Wrench size : 17 mm 8 Tightening torque : 25 to 35 N·m (2.5 to 3.5 kgf·m, 18 to 26 lbf·ft) 7 11. After replacing the filter element, bleed any remaining air from the hydraulic circuit while running the engine at a slow speed for approx. 3 minutes. 6 M503-07-031 12. Check the oil level gauge (9) in the hydraulic oil tank. Add oil as needed. 13. Install under cover (2) with bolts (3). 14. Tighten the hydraulic oil tank cap. 9 M1NC-00-002 2 3 ZX14-3, 16-3, 18-3 9 M1NC-07-009 ZX27-3 M1NC-05-011 7-36