MAINTENANCE Replace Pilot Filter --- every 1000 hours 6 d WARNING: Be sure to work only after oil temperature is low or before operation. Failure to do so may allow high temperature oil to spray, possibly causing severe burns. 1. Park the machine on a solid level surface. Position the machine with the arm cylinder fully retracted and the bucket cylinder fully extended. Lower the bucket and blade to the ground. Stop the engine. M1M7-05-024 2. Before replacing the element, be sure to loosen the hydraulic oil tank cap to release the air pressure from the hydraulic oil tank. 1 M1NC-00-010 1 ZX14-3, 16-3, 18-3 ZX27-3 M1NC-05-011 2 3 3.
Remove bolts (3) to remove under cover (2) from the rear left bottom side of the base machine. Wrench size : 17 mm Tightening torque : 50 N·m (5 kgf·m, 36 lbt·ft) M1NC-07-009 7-35