hitachi — Hitachi ZX14-3/ZX16-3/ZX18-3/ZX27-3 Hydraulic Excavator Operator's Manual

MAINTENANCE f NOTE: When disconnecting a coupler located in a narrow space that is difficult for your hand to enter, use a screwdriver following the procedures as described below. Using Screwdriver A screwdriver with a tip thickness of less than 1 mm and a tip width of approx. 5 mm is appropriate to this work. Slightly push the hose toward the coupler approx. 2 mm. While pushing the hose toward the coupler, insert a screwdriver in the position as illustrated to the right. Twist the screwdriver about 90 °. After making the gap between the adapter and the dust prevention cover more than 2 mm, pull the hose to disconnect the coupler. M1LA-07-021 Dust Prevention Cover Adapter Screwdriver 3.

Precautions for Re-using Coupler Before connecting the coupler, be sure to check the coupler surface for any adhered foreign matter. Clean to remove the foreign matter if any. Adhered foreign matter may cause oil leaks and/or disconnection of the coupler. When a hose clamping is required, put a clamp 200 mm away from the joint edge. If the hose is clamped as illustrated to the right, the coupler joint may slide as oil pressure changes, causing oil leaks due to the premature inner parts wear. Do not use the coupler as a foot step and do not handle the coupler roughly. If the dust prevention cover is broken, the coupler may become difficult to disconnect. Do not paint on the joint surface.

The body will be seized with the dust prevention cover so that the coupler cannot be disconnected. M1LA-07-022 M1LA-07-019 WRONG Less than 200 mm M1LE-07-006 7-43