MAINTENANCE Installing Rubber Track 1. Lower the bucket to raise one track off ground. Place 1 2 Grease Outlet blocks under machine frame to support the machine. 2. Slowly turn valve (1) counterclockwise to allow grease to escape from the grease outlet. 3. Engage the rubber track with the sprocket and position the other end of the rubber track on the front idler. 4. While rotating the sprocket in reverse, apply horizontal force to the rubber track to seat it on the idler. M1LA-07-036 5. Insert a steel pipe into gaps among lower rollers, track frame and rubber track and rotate the rubber track slowly to correctly seat the rubber track on the idler. Direction of Rotation 6.
Confirm that the rubber track is correctly engaged with the sprocket and idler. 7. Adjust track sag. (See page 7-67.) 8. After checking that the rubber track is correctly engaged with the sprocket and idler and the track sag is correctly adjusted, lower the machine to the ground. Steel Pipes M503-07-062 Direction of Rotation Steel Pipes M503-07-063 7-70