MAINTENANCE Loosen Track (Steel Crawler) d CAUTION: Do not loosen valve (1) too quickly or too much as high-pressure grease in the adjusting cylinder may spout out. Loosen carefully, keeping body parts and face away from valve (1). Never loosen grease fitting (2). IMPORTANT: When gravel or mud is packed around the components in the undercarriage, remove it before loosening valve (1). 1. To loosen track, slowly turn valve (1) counterclockwise using a socket wrench (long socket 19); grease will escape from grease outlet. M1LA-07-013 2. Between 1 and 1.5 turns of valve (1) are sufficient to loosen track. Never attempt to loosen the valve further. 3.
If grease does not drain smoothly, raise the track to be 1 2 Grease Outlet 4. When proper track sag is obtained, turn valve (1) loosed off the ground and slowly rotate the track. clockwise and tighten it to 88 N·m (9 kgf·m, 65 lbf·ft). Tighten Track (Steel Crawler) d CAUTION: In case the track sag is not adjustable, M1LA-07-036 this is a very hazardous situation. Since the track adjuster spring is excessively loaded, the grease pressure inside the track adjuster cylinder is very high. Incorrect adjustment or disassembly may result in personal injury and/or death. Immediately consult your nearest Hitachi dealer for repair.
1 2 Grease Outlet To tighten track, connect a grease gun to cylinder grease fitting (2) located inside the side frame and add grease until the sag is within specifications. M1LA-07-036 7-72