STORAGE Removing Machine from Storage d CAUTION: Start the engine ONLY in a well-ventilated place. 1. Remove grease from the cylinder rods if coated. 2. Adjust alternator and fan belt tension. 3. Fill the fuel tank. Bleed air from the fuel system. Check all fluid levels. 4. Start the engine. Run the engine at half speed for several minutes before beginning full load operation. 5. Operate all hydraulic functions several cycles. 6. Carefully check all systems before operating the machine with a full load. f NOTE: When the machine has been stored for a long time, be sure to perform the following steps as well: (a) Check the condition of all hoses and connections. (b) Warm up the engine.
(c) Stop the engine. (d) Install new fuel filters. Replace the engine oil filter and fill the engine with oil. IMPORTANT: If the machine is not used for a long time, oil films on sliding surfaces may have break down. Operate the travel, swing and digging functions, 2 to 3 cycles each to lubricate the sliding surfaces. 10-2