OPERATING ENGINE ZX27-3 1. Check that pilot control shut-off lever (1) is in the LOCK 1 position. 2. Turn engine control lever (3) to around the middle between the slow and fast idle positions. 3. Turn the key switch (2) to ON position. The preheat indicator (4) will light. 4. Sound the horn to alert bystanders. 5. As soon as preheat indicator (4) goes OFF, return key switch (2) to the START position to run the starter. IMPORTANT: Prevent starter damage and/or battery over discharge. Never run the starter for more than 10 seconds at a time. If the engine fails to start, return the key switch to OFF. Wait for more than 30 seconds, then try again. started.
It will automatically return to the ON position. f NOTE: This machine is equipped with Auto Glow System. 6. Release key switch (2) immediately after the engine has M1NC-05-004 2 Sensing the coolant temperature, the duration of preheating is automatically set. Be sure to wait until the preheat indicator goes off with the key switch turned to the ON position, as specified above. When atmospheric temperature is low, it is possible to operate the starter motor for within 15 seconds at a time. M1M7-01-007 3 M1NC-00-007 4 M1NC-01-022 3-4