TRANSPORTING THE MACHINE ON ANOTHER VEHICLE Make sure that the ramp pairs are of the same length, firmly attached to the trans- porting vehicle, parallel to each other, and perpendicular to the rear edge of the loading platform. Make sure that the ramps are positioned at the right distance for the width of the machine’s track. Position the ramps at a maximum angle of 15 ° . Remove all traces of oil, grease, or ice from the ramps and the loading platform. Do not correct steering on the ramps. If correction is required, reverse down off the ramps and re-align the machine before trying again. 1 - Load the machine onto the vehicle with the bucket (1) facing forward, i.e.
in the direction of travel of the vehicle, and at a suitable height from the ground. 2 - On completion of loading, rotate the revolving frame through 180˚ to avoid the truck's cab, and engage the revolving frame rotation lock. Lower the blade (2) and the equipment into contact with the loading platform. Engage the equipment control lock. 3 - Switch off the engine and remove the ignition key. 4 - Block the machine with (3) wedges in front of and behind the tracks. 5 - Tie the machine down with cables or chains (4) using the anchoring points provided (6 and 7). 6 - Protect the end of the exhaust pipe (5). 6 F00700 7 F00701 D00831 3 5 3 1 2 Max. 15° @@@@@@@@@ ЂЂЂЂЂЂЂЂЂ ААААААААА 4 4 81