MAINTENANCE GUIDE 24. MAINTENANCE GUIDE Engage all the locks and safety devices and switch off the engine before opening the engine compartment. Before checking the level of the hydraulic fluid, retract the bucket and arm cylinders, extend the articulated boom cylinders and lower the teeth of the bucket to the ground. Only carry out maintenance on firm, level ground. Choose the right lubricants for the ambient temperatures encountered. Use only clean oils and greases. Make sure that all lubricant containers are clean, and that no dirt has got into them. Keep the machine perfectly clean. This makes it far easier to see broken or faulty parts.
Keep all grease nipples, breathers, and the fluid level inspection areas clean to prevent dirt from entering the systems. It is dangerous to drain coolant or oil when the engine is still hot. Wait for the engine to cool to a safe temperature of 40 ч 45 ° C. When changing oil and filters, check for metal particles. If these are present in any quan- tity, consult your FKI dealer. Only check and change the hydraulic fluid with the machine parked in a clean area, to prevent dirt from entering the hydraulic system. Before starting maintenance work, attach warning notices to the ignition switch, control levers, and cab door to avoid the engine being started while you are working.
Observe the precautions given on the various safety notices on the machine while per- forming maintenance. Instructions for arc welding: - Turn the ignition key to « O » position. - Disconnect the battery (negative terminal first, and then positive terminal). - Disconnect the alternator. - Never apply a current of over 200 V continuous. - Connect the welder’s negative (earth) cable to a point on the machine frame no further than 1 metre from the point to be welded. - Do not attach the negative cable in such a way that bearings or seals lie between it and the welding point. Never use inflammable liquids to clean parts. Avoid naked flames. Refrain from smoking.
When removing seals and O-rings, thoroughly clean the seats and always fit new seals and O-rings. Make sure that seals and O-rings are properly seated when re-assembling parts. 98