Komatsu — 25.3 ELECTRICAL SYSTEM MAINTENANCE NOTES

MAINTENANCE NOTES 25.2 HYDRAULIC SYSTEM MAINTENANCE NOTES Take great care when working on the hydraulic circuit. Remember that after a day’s work the hydraulic fluid is very hot. High pressures are also present in the circuit not only while the machine is working, but even after completion of work. The hydraulic system requires the following maintenance: 1 - Daily checks of fluid level in the tank; 2 - Scheduled changes of the hydraulic system filter; 3 - Scheduled changes of hydraulic fluid. After the filter or hydraulic fluid has been changed, all air must be led out of the system.

When any part of the hydraulic circuit is removed, check the seals and O-rings, and fit new ones if they are damaged. If a cylinder or any other component of the hydraulic system is removed, air must be bled from the system after re-assembly. To do so, proceed as follows: 1 - Start the engine and allow it to run at low revs. 2 - Perform 4 ч 5 manoeuvres with all the cylinders up to about 100 mm from the end of stroke. 3 - Perform 3 ч 4 slow manoeuvres with all the cylinders up to the complete end of stroke. 25.3 ELECTRICAL SYSTEM MAINTENANCE NOTES If electrical cables are damp or their insulation damaged, current can leak from the electri- cal system and cause malfunctions.

The electrical system requires the following maintenance: 1 - Check fan belt tension; 2 - Check the fan belt for damage or breakage; 3 - Check for electrolyte level in the battery. Do not remove any standard component of the electrical system, and do not install any new component unless approved by FKI. Avoid wetting the electrical system when washing the machine, and keep rain off it. If you have to work for any extended period on the banks of rivers or lakes or on the sea shore, protect all electrical connectors with a suitable anti-corrosion product. Do not connect any optional equipment to the fuses, ignition switch, battery, or relays, etc..

Consult your FKI dealer for the best way to install optional. Disconnect the battery and the alternator before performing any welding. 102