SCHEDULED MAINTENANCE 29.4 EVERY 100 HOURS # Every 100 hours, perform the following operations in addition to those scheduled for every 50 hours. 29.4.a GREASING THE ARTICULATIONS IMPORTANT Clean the greasing nipples before applying the grease gun. Clean up any old grease forced out of the articulations when you finish. Perform these operations more frequently if the machine is working in harsh conditions. The equipment must be extended and resting on the ground in order to perform these operations. Use only the recommended greases. (See section «26.
FUEL, COOLANT, AND LUBRICANTS».) IMPORTANT As a general rule, each hydraulic cylinder has two greasing points, one at each end, and each link or fulcrum pin has at least one greasing point. BLADE D00062 3 2 1 @@@@ AAAA BBBB CCCC ЂЂЂЂ ЃЃЃЃ ‚‚‚‚ ѓѓѓѓ АААА ББББ ВВВВ ГГГГ 1 - Blade cylinder rod end (1 point) 3 - Blade arm fulcrum pin (2 points) 4 - Blade cylinder foot pin (1 point) 116