Komatsu — 29.5 AFTER THE FIRST 250 HOURS

SCHEDULED MAINTENANCE 29.4.c GREASING THE FIFTH WHEEL Thoroughly clean the greasing nipples (1) before applying the grease gun. Use only the recommended grease. (See section «26. FUEL, COOLANT, AND LUBRICANTS».) When you finish, check that you have greased all the points needing it, and clean off any old grease forced out of the fifth wheel. 1 1 IMPORTANT Grease all four grease nipples (arranged at 180 ° one to the other) to make sure that fresh grease is evenly distributed. F00286 29.4.d LUBRICATION OF THE OVERLOAD DEVICE CAM Thoroughly clean the greasing nipple (1) before applying the grease gun. Use only the recommended grease. (See section «26.

FUEL, COOLANT, AND LUBRICANTS».) When you finish, check that you have greased all the point needing it, and clean off any old grease forced out. F00845 1 29.5 AFTER THE FIRST 250 HOURS # Perform the following operations at the end of the first 250 hours operation in addition to those scheduled for every 250 hours. CHANGE THE FINAL DRIVES OIL. CHANGE THE SWING MOTOR OIL. CHECK AND ADJUST THE VALVE CLEARANCE. See the sections «EVERY 2000 HOURS» for details on these jobs. Consult your FKI dealer to have the valve clearance checked and adjusted. 120