SCHEDULED MAINTENANCE 2 - Use the filter wrench provided to remove the filter. Dispose of the old filter correctly. 3 - Clean the inside of the filter seat (3), and check that the filter alignment dowel is secure in its seat. 4 - Smear the seals of the new filter element with clean diesel fuel and screw the element in to the filter seat until the seal grips. 5 - Tighten a further half turn by hand. 6 - Bleed the air from the fuel circuit. 1 FUEL PUMP GAUZE FILTER 1 - Remove the cover and seal (2) from fuel pump (1), and remove the gauze filter (3). 2 - Thoroughly clean inside the pump (1) and also clean the gauze filter (3) and cover and seal (2).
3 - Reassemble, checking that the seal is in per- fect condition and correctly seated. 4 - Bleed the air from the fuel circuit. F00664 4 BLEEDING AIR FROM THE FUEL CIRCUIT 1 - Turn the ignition key to position « I ». 2 - Press and hold down the fuel pump push-but- ton (4) for about 2 minutes. F00702 IMPORTANT If the fuel pump push-button (4) does not move, crank the engine through one complete revolu- tion. 3 - Start the engine. IMPORTANT If the engine starts normally but then runs roughly or stops, check for air in the fuel cir- cuit. If air is found, check the seal of the fuel filter and fuel pump. 129