SCHEDULED MAINTENANCE 1 - Remove filler cap (1). Use the 24 mm wrench. 2 - Remove the botton cover under the fuel tank, remove drain plug (2) and drain all the old fluid out into a suitable container. Use the 17 and 27 mm wrench. 3 - Remove the hydraulic tank inspection panel (3) and fit a new filter (See section «29.6.e CHANGING THE HYDRAULIC SYSTEM FIL- TER»). Use the 13 mm wrench. 4 - Replace the drain plug (2) and tank inspection panel (3), checking that the panel seal is in good condition and correctly seated. F00704 5 - Fill the system with new fluid of the type rec- ommended, up to level inspection window (4).
6 - Open the engine bonnet, losen the pump bleed screw (5), expel any remaining air from the oil. Use the 12 mm wrench. Tighten screw (5). 2 7 - Replace filler cap (1) and start the engine. Operate every hydraulic cylinder a number of times to remove air from the system. Check the level again and top up if necessary. Use only the recommended fluid for filling the system. (See section «26. FUEL, COOLANT, AND LUBRICANTS»). 5 8 - Replace the botton cover under the fuel tank. IMPORTANT Never start the engine while the hydraulic tank is empty, since this would cause certain damage to the pump. F00851 133